Brightsign Object Reference Manual (FW 5.1) Bedienungsanleitung PDF herunterladen (Seite 274)

266

roControlPort

This object is an improved version of roGpioControlPort. It provides support for the I/O port of the BP200 and BP900 USB

button boards, as well as the on-board I/O port and side buttons on the BrightSign player. It also supports "button-up"

events. The object is used to configure output levels on the I/O connector and monitor inputs. Typically, LEDs and buttons

are attached to the I/O connector on the BrightSign player or the BrightSign Expansion Module.

Object Creation: The roControlPort object is created with a single parameter that specifies the port being used.

CreateObject("roControlPort", port As String)

The port parameter can be one of the following:

• BrightSign: Specifies the onboard DA-15 connector, as well the SVC (GPIO12) and Reset buttons.

• Expander-GPIO: Specifies the DB-25 connector on the BrightSign Expansion Module. If no BrightSign Expansion

module is attached, then object creation will fail and Invalid will be returned.

• Expander-DIP: Specifies the eight DIP switches on the BrightSign Expansion Module. If no BrightSign Expansion

module is attached, then object creation will fail and Invalid will be returned.

Note: Hot-plugging the BrightSign Expansion Module is not supported.

• Touchboard-<n>-GPIO: Retrieves events from the specified BP200/BP900 button board. Events are handled in

the same manner as events from the BrightSign port.

• Touchboard-<n>-LED-SETUP: Sets various LED output options for the specified BP200/BP900 button board.

• Touchboard-<n>-LED: Sets the bits for each button on the specified BP200/BP900 button board. The bits

indicate whether the associated LED should be on or off.

Note: Since multiple BP200/BP900 button boards can be connected to a player simultaneously, the <n> value

specifies the port enumeration of each board. An unspecified enumeration value is synonymous with a button board

with an enumeration value of 0 (e.g. Touchboard-GPIO and Touchboard-0-GPIO are identical).

1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 340 341

Brightsign Object Reference Manual (FW 5.1) Bedienungsanleitung Seite 274