BrightSign XD230 Betriebsanweisung PDF herunterladen (Seite 115)

109

Variables

Use this tab to create User Variables and enable Media Counters.

• Media Counter: A value that records how many times a file in the presentation has played. They can be

viewed in Live Text or extracted from the BrightSign via USB. Media Counters are not recorded unless you

check the Automatically create media counter variables checkbox in the Variables tab. When enabled,

Media Counters are recorded for every file in the presentation. However, in Live Text, only Media Counters

that are individually added can be viewed. For details on retrieving all Media Counters via USB, see Using

advanced tools.

• User Variable: A customizable value that can be used in commands or displayed in Live Text. When used

in Live Text, User Variables display the current value of the variable. This value can continually change

during a presentation. The value of a User Variable can be changed during a presentation by using the Set

Variable or Reset Variable commands.

User Variables can be used in the following commands: Set Volume, Increment Volume, Decrement

Volume, Send UDP, Serial-send string (EOL), Serial-send string (no EOL), Serial-send byte, Serial-send

bytes (comma separated), Synchronize, Send Zone Message, Link Zones, GPIO On, GPIO Off, GPIO Set

State, BrightControl – Send Ascii String, BrightControl – Philips Set Volume, Pause.

For example, if you add a Set Volume command to your presentation and use a static value like 50, the

volume will always be set to 50 when the command occurs. If you use a User Variable instead, the volume

will be set to the current value of the variable, which could be any number of values based on your Set

Variable commands and when the User Variable is used.

To utilize a User Variable in a command, add the desired command as you normally would. See Adding

Commands for details. In the Parameters field, type the exact name of the variable in between two dollar

signs on each side (e.g. “$$variable1$$”). BrightAuthor will not recognize the variable without these dollar

signs.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 132 133

Keine Kommentare

BrightSign XD230 Betriebsanweisung Seite 115